BoardPilotSSD1327 1.5" grayscale OLED 128x128 (SPI) con ESP32
Alimentazione 3.3-5 V
Bus SPI
Pin e collegamento all’ESP32
| Pin | Ruolo | Pin ESP32 | Note |
|---|---|---|---|
| VCC | Alimentazione | 3V3 | Pin order varies between boards: match by the printed label. 3.3 V or 5 V |
| GND | Massa | GND | |
| DIN | SPI MOSI | D23 | SPI data (MOSI). In I2C mode (resistors moved on the back) this is SDA |
| CLK | Clock SPI | D18 | SPI clock. In I2C mode this is SCL |
| CS | Chip select SPI | D5 | |
| DC | Ingresso (lo pilota l’ESP32) | D25 | Data / command select |
| RST | Ingresso (lo pilota l’ESP32) | D26 | Reset |
Collegamento consigliato per l’ESP32 DevKit a 30 pin, evitando i pin della flash, di sola lettura e di strapping. BoardPilot lo controlla mentre colleghi.
Fonti
- Solomon Systech SSD1327 datasheet, 4-wire SPI and I2C interfaces; 16 gray levels
- Waveshare 1.5inch OLED Module wiki, Pins VCC, GND, DIN, CLK, CS, DC, RST; SPI by default
Provalo in 3D in BoardPilot
Componenti simili
APA102 / SK9822 LED strip (clock + data)E-paper 1.54" 200x200 (SPI)E-paper 2.13" 250x122 (SPI)E-paper 2.9" 296x128 (SPI)E-paper 4.2" 400x300 (SPI)GC9A01 1.28" round IPS 240x240 (SPI)
Dati dei componenti: CC BY 4.0, riutilizzabili citando BoardPilot.