BME280 with Nordic nRF52840 DK

Wiring for the GY-BME280 breakout on the Nordic nRF52840 DK (nRF52840-QIAA, 3.3 V logic), chosen with the same pin rules BoardPilot uses: default buses first, and no pins that are used for flash, USB, the debugger or booting.

Wiring

Check before you power it on

• Supply: 3 V from the VDD pin.
• I2C uses the board’s default pins P0.26 (SDA) and P0.27 (SCL). Most modules include pull-up resistors; if the part is not found, check them and swap-test SDA/SCL.
• To make sure it is the real chip, read register 0xD0: a genuine part answers 0x60.

Test code (Arduino)

#include <Wire.h>

void setup() {
  Serial.begin(115200);
  Wire.begin();  // SDA = P0.26, SCL = P0.27 (the board's default I2C pins)
  Wire.beginTransmission(0x76);
  bool found = Wire.endTransmission() == 0;
  Serial.println(found ? "GY-BME280 breakout found at 0x76" : "Not found: check power, GND and SDA/SCL");
}

void loop() {}

Arduino board: adafruit:nrf52:pca10056. Plug USB into the port on the short edge (interface MCU, J2) and set the power switch to ON; before the first Arduino sketch, burn the Adafruit bootloader and SoftDevice once.

Questions

Which Nordic nRF52840 DK pins do I use for the BME280?

VIN → VDD, GND → GND, SCL → P0.27, SDA → P0.26.

Does the BME280 work with the Nordic nRF52840 DK at 3.3 V?

Yes: the BME280 runs at 3.3 V and the Nordic nRF52840 DK uses 3.3 V signals, so no level shifting is needed.

What is the I2C address of the BME280?

0x76 or 0x77. An I2C scan (BoardPilot does it for you) shows which one your module uses.

Full Nordic nRF52840 DK pinout · GY-BME280 breakout: all pins and data

The BME280 on other boards

ESP32 DevKit Arduino Mega 2560 R3 Arduino Nano Arduino Uno R3 WeAct Black Pill STM32F411CE ESP32-C3-DevKitM-1 ESP32-S3-DevKitC-1 NUCLEO-F401RE Raspberry Pi Pico 2 Raspberry Pi Pico W Raspberry Pi Pico Teensy 4.1

Other parts on the Nordic nRF52840 DK

BMP280 DHT22 DHT11 HC-SR04 SSD1306 OLED MPU6050 DS18B20 WS2812B LED strip SG90 servo Relay module HC-SR501 PIR LCD 1602 I2C INA219 VL53L0X BH1750 MAX30102 RC522 RFID NEO-6M GPS Capacitive soil moisture sensor ADS1115 TM1637 28BYJ-48 stepper L298N Potentiometer Push button LED Joystick module SD card module AHT20