LED with Raspberry Pi Pico 2

Wiring for the LED with 220 Ω resistor on the Raspberry Pi Pico 2 (RP2350, 3.3 V logic), chosen with the same pin rules BoardPilot uses: default buses first, and no pins that are used for flash, USB, the debugger or booting.

Wiring

LED pin	Role	Raspberry Pi Pico 2 pin	Notes
A	Input to the part	GP15	Anode (long leg), through the resistor to a GPIO
K	Ground	GND	Cathode (short leg, flat side)

Check before you power it on

Test code (Arduino)

void setup() {
  pinMode(15, OUTPUT);  // A on GP15
}

void loop() {
  digitalWrite(15, HIGH);
  delay(500);
  digitalWrite(15, LOW);
  delay(500);
}

Arduino board: rp2040:rp2040:rpipico2. If the board is not found, hold the BOOTSEL button while plugging in the USB cable.

Questions

Which Raspberry Pi Pico 2 pins do I use for the LED?

A → GP15, K → GND.

Does the LED work with the Raspberry Pi Pico 2 at 3.3 V?

Yes: the LED runs at 3.3 V and the Raspberry Pi Pico 2 uses 3.3 V signals, so no level shifting is needed.

BoardPilot checks this wiring in 3D as you build it, and finds crossed or missing wires on the real board.

Download BoardPilot

Full Raspberry Pi Pico 2 pinout · LED with 220 Ω resistor: all pins and data

The LED on other boards

ESP32 DevKit Arduino Mega 2560 R3 Arduino Nano Arduino Uno R3 WeAct Black Pill STM32F411CE ESP32-C3-DevKitM-1 ESP32-S3-DevKitC-1 Nordic nRF52840 DK NUCLEO-F401RE Raspberry Pi Pico W Raspberry Pi Pico Teensy 4.1

Other parts on the Raspberry Pi Pico 2

BME280 BMP280 DHT22 DHT11 HC-SR04 SSD1306 OLED MPU6050 DS18B20 WS2812B LED strip SG90 servo Relay module HC-SR501 PIR LCD 1602 I2C INA219 VL53L0X BH1750 MAX30102 RC522 RFID NEO-6M GPS Capacitive soil moisture sensor ADS1115 TM1637 28BYJ-48 stepper L298N Potentiometer Push button Joystick module SD card module AHT20