LSM9DS1 9-axis IMU breakout con ESP32

Alimentazione 3.3-5 V Bus I2C Indirizzo I2C 0x6B / 0x6A / 0x1E / 0x1C Misura accelerazione, rotazione, campo magnetico, temperatura

Pin e collegamento all’ESP32

Pin	Ruolo	Pin ESP32	Note
VIN	Alimentazione	3V3	Adafruit-style pin order. SparkFun boards use other names and order
3VO	Non collegato all’ESP32	—	Output of the on-board 3.3 V regulator. Leave unconnected
GND	Massa	GND
SCL	Clock I2C (SCL)	D22
SDA	Dati I2C (SDA)	D21
CSAG	Non collegato all’ESP32	—	Accel/gyro SPI select. Leave unconnected for I2C
CSM	Non collegato all’ESP32	—	Magnetometer SPI select. Leave unconnected for I2C
SDOAG	Non collegato all’ESP32	—	Accel/gyro address: HIGH = 0x6B, LOW = 0x6A
SDOM	Non collegato all’ESP32	—	Magnetometer address: HIGH = 0x1E, LOW = 0x1C
INT1	Interrupt	D35	Accel/gyro interrupt, optional
INT2	Interrupt	VP	Accel/gyro interrupt, optional
INTM	Interrupt	VN	Magnetometer interrupt, optional
DRDY	Interrupt	D34	Magnetometer data ready, optional

Collegamento consigliato per l’ESP32 DevKit a 30 pin, evitando i pin della flash, di sola lettura e di strapping. BoardPilot lo controlla mentre colleghi.

Codice di partenza (Arduino)

#include <Wire.h>

void setup() {
  Serial.begin(115200);
  Wire.begin(21, 22);  // SDA = GPIO 21, SCL = GPIO 22
  Wire.beginTransmission(0x6B);
  bool found = Wire.endTransmission() == 0;
  Serial.println(found ? "LSM9DS1 9-axis IMU breakout found at 0x6B" : "Not found: check power, GND and SDA/SCL");
}

void loop() {}

Fonti

ST LSM9DS1 datasheet, WHO_AM_I 0x0F: accel/gyro reads 0x68, magnetometer reads 0x3D (two I2C devices)
ST LSM9DS1 datasheet, I2C addresses: accel/gyro 0x6A/0x6B, magnetometer 0x1C/0x1E

Provalo in 3D in BoardPilot

BoardPilot Dati del componente (JSON)

Componenti simili

ADS1015 12-bit ADCADS1115 16-bit ADCADXL375 high-g accelerometer (±200 g)AHT10 temperature + humidityAHT20 + BMP280 combo moduleAHT20 temperature + humidity

Dati dei componenti: CC BY 4.0, riutilizzabili citando BoardPilot.