BoardPilotActive buzzer with ESP32
Supply 3.3-5 V
Bus GPIO
Pins and ESP32 wiring
| Pin | Role | ESP32 pin | Notes |
|---|---|---|---|
| + | Input (the ESP32 drives it) | D25 | Longer leg. To a GPIO: HIGH beeps. Loud buzzers need a transistor |
| - | Ground | GND |
Suggested wiring for the 30-pin ESP32 DevKit, avoiding flash, input-only and strapping pins. BoardPilot checks it for you as you wire.
Starter code (Arduino)
void setup() { pinMode(25, OUTPUT); } // +
void loop() {
digitalWrite(25, HIGH);
delay(500);
digitalWrite(25, LOW);
delay(500);
}Sources
- Generic 12 mm active buzzer datasheet, Built-in oscillator: sounds with DC applied
Try it in 3D in BoardPilot
Related parts
18650 Li-ion cell in holder28BYJ-48 stepper + ULN2003 driver433 MHz transmitter (FS1000A)74HC595 shift registerA4988 stepper driverAMS1117-3.3 regulator module
Part data: CC BY 4.0, free to reuse with credit to BoardPilot.