Slide switch (SPDT) with ESP32

Supply 3.3 V Bus GPIO

Pins and ESP32 wiring

Pin	Role	ESP32 pin	Notes
A	Output (the part drives it)	D25	To a GPIO; use INPUT_PULLUP. LOW when the slider is on this side
COM	Ground	GND	Middle pin
B	Not wired to the ESP32	—	Leave unconnected, or use a second GPIO

Suggested wiring for the 30-pin ESP32 DevKit, avoiding flash, input-only and strapping pins. BoardPilot checks it for you as you wire.

void setup() {
  Serial.begin(115200);
  pinMode(25, INPUT);  // A
}

void loop() {
  Serial.println(digitalRead(25));
  delay(100);
}

Part data: CC BY 4.0, free to reuse with credit to BoardPilot.