MPU6050 with Arduino Mega 2560 R3

Wiring for the MPU6050 (GY-521) accelerometer + gyro on the Arduino Mega 2560 R3 (ATmega2560, 5 V logic), chosen with the same pin rules BoardPilot uses: default buses first, and no pins that are used for flash, USB, the debugger or booting.

Wiring

Check before you power it on

• Supply: 5 V from the 5V pin.
• I2C uses the board’s default pins SDA 20 (SDA) and SCL 21 (SCL). Most modules include pull-up resistors; if the part is not found, check them and swap-test SDA/SCL.
• To make sure it is the real chip, read register 0x75: a genuine part answers 0x68.

Test code (Arduino)

#include <Wire.h>

void setup() {
  Serial.begin(115200);
  Wire.begin();  // SDA = SDA 20, SCL = SCL 21 (the board's default I2C pins)
  Wire.beginTransmission(0x68);
  bool found = Wire.endTransmission() == 0;
  Serial.println(found ? "MPU6050 (GY-521) accelerometer + gyro found at 0x68" : "Not found: check power, GND and SDA/SCL");
}

void loop() {}

Arduino board: arduino:avr:mega.

Questions

Which Arduino Mega 2560 R3 pins do I use for the MPU6050?

VCC → 5V, GND → GND, SCL → SCL 21 (PD0), SDA → SDA 20 (PD1), INT → ~2 (PE4).

Does the MPU6050 work with the Arduino Mega 2560 R3 at 5 V?

Yes: the MPU6050 runs at 3.3-5 V and the Arduino Mega 2560 R3 uses 5 V signals, so no level shifting is needed.

What is the I2C address of the MPU6050?

0x68 or 0x69. An I2C scan (BoardPilot does it for you) shows which one your module uses.

Full Arduino Mega 2560 R3 pinout · MPU6050 (GY-521) accelerometer + gyro: all pins and data

The MPU6050 on other boards

ESP32 DevKit Arduino Nano Arduino Uno R3 WeAct Black Pill STM32F411CE ESP32-C3-DevKitM-1 ESP32-S3-DevKitC-1 Nordic nRF52840 DK NUCLEO-F401RE Raspberry Pi Pico 2 Raspberry Pi Pico W Raspberry Pi Pico Teensy 4.1

Other parts on the Arduino Mega 2560 R3

BME280 BMP280 DHT22 DHT11 HC-SR04 SSD1306 OLED DS18B20 WS2812B LED strip SG90 servo Relay module HC-SR501 PIR LCD 1602 I2C INA219 VL53L0X BH1750 MAX30102 RC522 RFID NEO-6M GPS Capacitive soil moisture sensor ADS1115 TM1637 28BYJ-48 stepper L298N Potentiometer Push button LED Joystick module SD card module AHT20