SG90 servo with Arduino Mega 2560 R3

Wiring for the SG90 micro servo on the Arduino Mega 2560 R3 (ATmega2560, 5 V logic), chosen with the same pin rules BoardPilot uses: default buses first, and no pins that are used for flash, USB, the debugger or booting.

Wiring

SG90 servo pin	Role	Arduino Mega 2560 R3 pin	Notes
GND	Ground	GND	Brown wire
VCC	Power	5V
SIG	Input to the part	22 (PA0)	Orange wire. 50 Hz PWM, 0.5 to 2.4 ms pulses

Check before you power it on

Supply: 5 V from the 5V pin.
Motors, servos, relays and LED strips can draw more current than the Arduino Mega 2560 R3’s pins or USB can give. Power them separately and connect the grounds together.

Test code (Arduino)

// Library: Servo
#include <Servo.h>

Servo servo;

void setup() {
  servo.attach(22);
}

void loop() {
  servo.write(0);
  delay(1000);
  servo.write(90);
  delay(1000);
  servo.write(180);
  delay(1000);
}

Arduino board: arduino:avr:mega.

Questions

Which Arduino Mega 2560 R3 pins do I use for the SG90 servo?

GND → GND, VCC → 5V, SIG → 22 (PA0).

Does the SG90 servo work with the Arduino Mega 2560 R3 at 5 V?

Yes: the SG90 servo runs at 5 V and the Arduino Mega 2560 R3 uses 5 V signals, so no level shifting is needed.

BoardPilot checks this wiring in 3D as you build it, and finds crossed or missing wires on the real board.

Download BoardPilot

Full Arduino Mega 2560 R3 pinout · SG90 micro servo: all pins and data

The SG90 servo on other boards

ESP32 DevKit Arduino Nano Arduino Uno R3 WeAct Black Pill STM32F411CE ESP32-C3-DevKitM-1 ESP32-S3-DevKitC-1 Nordic nRF52840 DK NUCLEO-F401RE Raspberry Pi Pico 2 Raspberry Pi Pico W Raspberry Pi Pico Teensy 4.1

Other parts on the Arduino Mega 2560 R3

BME280 BMP280 DHT22 DHT11 HC-SR04 SSD1306 OLED MPU6050 DS18B20 WS2812B LED strip Relay module HC-SR501 PIR LCD 1602 I2C INA219 VL53L0X BH1750 MAX30102 RC522 RFID NEO-6M GPS Capacitive soil moisture sensor ADS1115 TM1637 28BYJ-48 stepper L298N Potentiometer Push button LED Joystick module SD card module AHT20