Push button with Arduino Mega 2560 R3

Wiring for the Push button on the Arduino Mega 2560 R3 (ATmega2560, 5 V logic), chosen with the same pin rules BoardPilot uses: default buses first, and no pins that are used for flash, USB, the debugger or booting.

Wiring

Push button pin	Role	Arduino Mega 2560 R3 pin	Notes
1	Output from the part	22 (PA0)	To a GPIO; use INPUT_PULLUP in code
2	Ground	GND

Check before you power it on

The Push button is a 3.3 V part and the Arduino Mega 2560 R3 uses 5 V signals. Power it from 3.3 V and put a level shifter on the signal wires, or buy a 5 V version of the module.

Test code (Arduino)

void setup() {
  Serial.begin(115200);
  pinMode(22, INPUT_PULLUP);  // pressed = LOW
}

void loop() {
  Serial.println(digitalRead(22) == LOW ? "pressed" : "released");
  delay(100);
}

Arduino board: arduino:avr:mega.

Questions

Which Arduino Mega 2560 R3 pins do I use for the Push button?

1 → 22 (PA0), 2 → GND.

Does the Push button work with the Arduino Mega 2560 R3 at 5 V?

The Push button is a 3.3 V part and the Arduino Mega 2560 R3 uses 5 V signals. Power it from 3.3 V and put a level shifter on the signal wires, or buy a 5 V version of the module.

BoardPilot checks this wiring in 3D as you build it, and finds crossed or missing wires on the real board.

Download BoardPilot

Full Arduino Mega 2560 R3 pinout · Push button: all pins and data

The Push button on other boards

ESP32 DevKit Arduino Nano Arduino Uno R3 WeAct Black Pill STM32F411CE ESP32-C3-DevKitM-1 ESP32-S3-DevKitC-1 Nordic nRF52840 DK NUCLEO-F401RE Raspberry Pi Pico 2 Raspberry Pi Pico W Raspberry Pi Pico Teensy 4.1

Other parts on the Arduino Mega 2560 R3

BME280 BMP280 DHT22 DHT11 HC-SR04 SSD1306 OLED MPU6050 DS18B20 WS2812B LED strip SG90 servo Relay module HC-SR501 PIR LCD 1602 I2C INA219 VL53L0X BH1750 MAX30102 RC522 RFID NEO-6M GPS Capacitive soil moisture sensor ADS1115 TM1637 28BYJ-48 stepper L298N Potentiometer LED Joystick module SD card module AHT20