Potentiometer with Arduino Nano

Wiring for the 10 kΩ potentiometer on the Arduino Nano (ATmega328P, 5 V logic), chosen with the same pin rules BoardPilot uses: default buses first, and no pins that are used for flash, USB, the debugger or booting.

Wiring

Check before you power it on

• Supply: 3.3 V from the 3V3 pin.
• The Potentiometer is a 3.3 V part and the Arduino Nano uses 5 V signals. Power it from 3.3 V and put a level shifter on the signal wires, or buy a 5 V version of the module.

Test code (Arduino)

void setup() {
  Serial.begin(115200);
}

void loop() {
  long mv = (long)analogRead(14) * 5000L / 1023;  // OUT on A0
  Serial.println(mv);
  delay(200);
}

Arduino board: arduino:avr:nano. Clones with the old bootloader upload at 57600 baud: choose “ATmega328P (Old Bootloader)” if uploads fail.

Questions

Which Arduino Nano pins do I use for the Potentiometer?

VCC → 3V3, OUT → A0 (PC0), GND → GND.

Does the Potentiometer work with the Arduino Nano at 5 V?

The Potentiometer is a 3.3 V part and the Arduino Nano uses 5 V signals. Power it from 3.3 V and put a level shifter on the signal wires, or buy a 5 V version of the module.

Full Arduino Nano pinout · 10 kΩ potentiometer: all pins and data

The Potentiometer on other boards

ESP32 DevKit Arduino Mega 2560 R3 Arduino Uno R3 WeAct Black Pill STM32F411CE ESP32-C3-DevKitM-1 ESP32-S3-DevKitC-1 Nordic nRF52840 DK NUCLEO-F401RE Raspberry Pi Pico 2 Raspberry Pi Pico W Raspberry Pi Pico Teensy 4.1

Other parts on the Arduino Nano

BME280 BMP280 DHT22 DHT11 HC-SR04 SSD1306 OLED MPU6050 DS18B20 WS2812B LED strip SG90 servo Relay module HC-SR501 PIR LCD 1602 I2C INA219 VL53L0X BH1750 MAX30102 RC522 RFID NEO-6M GPS Capacitive soil moisture sensor ADS1115 TM1637 28BYJ-48 stepper L298N Push button LED Joystick module SD card module AHT20